6 Channel 12v Terminal Accessories Output Instructions

Thank you for purchasing the LEVUP Universal 6 Channel 12v Output Terminal 

Just a reminder to make sure you always check your wiring and everything you disconnect are in the right position. Please do not overload the PCB. You can only do what the Stock DC-DC can do. Most general accessories or extra headlight/turn signals/under glow is sufficient. 

Specs:

This terminal block allows you to output a CONSTANT 12v power for your accessories. It has a built in fuse for 15A to protect the DC-DC of the bike only. You need to add fuses to the accessories you are installing to protect them.

Yellow Wire = 12v

Black Wire = Ground

Note On the PCB::

A= Positive 12v

B= Negative

Please Follow the Labels on the casing for + and - positions!

Mounting the Terminal to your 80v RCR:

Potentially you can mount it anywhere you desire. However, I set this up right behind the battery inside the little cubical where the wires for your taillight is routed. The block has Velcro included and installed already and if you need to add or remove accessories you can just dismount it from the Velcro for easy access.

5V DC-DC Converter:

If you purchased the 5v converter, it is already preinstalled in the terminal block. You can use this to power a USB port or USB-C of your choice. If you bought my Control Module this will plug and play directly to it.